Range

Industtrial

Water-based two-component epoxy microcement for high-wear interior floors: shops, restaurants, hotels, garages, warehouses or offices. It offers high hardness, good abrasion resistance and lower water absorption than a conventional microcement.

  • Interior
  • Floors
  • Epoxy
  • Two-component
  • High traffic
Industtrial
System

How the system is applied

  1. 1 Primer

    Primacem Plus (recommended), ABS on absorbent substrates or Primapox Barrier if there is moisture. Apply the microcement while it is still tacky.

    Primacem® Plus 5L
  2. 2 Mix A+B

    Mix Component A with the matching size of Component B using a mixer at low speed until you have a smooth mass.

    Component B Industtrial 2,09Kg LQ ADR
  3. 3 Base coat

    Two coats of Industtrial XL or BASE as preparation. No mesh needed.

    Component A Industtrial BASE 18 Kg
  4. 4 Finish

    Two coats of MEDIO, slightly smoother, or LISO, fine-grain with a very soft texture.

    Component A Industtrial SMOOTH 18 Kg
  5. 5 Sealing

    Mandatory, 24–48 h after the last coat. Topsealer WT Dragon on floors.

    Component A Topsealer WT Dragon Satin 3L

Industtrial products

5 products
Component B Industtrial 0,52Kg LQ ADR Two-component
Component B Industtrial

Component B Industtrial 0.52Kg LQ ADR is the liquid epoxy hardener for the Industtrial system, formulated to provide maximum mechanical resistance, impermeability,...

From €28,450.52 kg · 2.09 kg
View product
Documentation

Industtrial technical data sheets

Frequently asked questions about Industtrial

What is Industtrial and what is it used for?
Industtrial is a two-component, water-based epoxy microcement for interiors, designed for heavily worn floors such as shopping centres, restaurants, hotels, garages, industrial units or offices. It offers high hardness, good abrasion resistance and lower water absorption than conventional microcements.
Do I need to buy both Component A and Component B?
Yes. Component A is the microcement (XL, BASE, MEDIO or LISO) and Industtrial Component B is the epoxy hardener that activates it. Choose the Component B that matches the size of your Component A and mix them with a mixer at low speed until you get a homogeneous mass.
Which grain size should I choose: XL, BASE, MEDIO or LISO?
XL and BASE are preparation coats: first apply two coats of either one. On top go two finishing coats: MEDIO, for a slightly smoother finish than BASE, or LISO, fine-grained with a very soft texture.
Can it be applied outdoors or over underfloor heating?
No. Industtrial is for indoor use only and, according to the technical data sheet, cannot be installed over underfloor heating.
What primer does the substrate need?
It depends on the substrate: Primacem PLUS on non-absorbent surfaces, Primacem ABS on absorbent ones and Primapox Barrier if there is capillary or vapour moisture. Topciment recommends Primacem PLUS for this system; apply the microcement while the primer is still tacky.
Does it need to be sealed afterwards?
Yes, it must always be sealed, 24-48 hours after the last coat. Topsealer WT Dragon is recommended for floors; on walls that will not be exposed to moisture, Topsealer WT All in One is enough.